Today, I made some more progress on the wing of my aircraft. I started this morning with the beginnings of rounding the leading edge by using a plane to take of the initial corner and then sand paper rounded over the leading edge moving top to bottom as well as along the leading edge from […]
Building Aero 3D Day 42: Various Aspects of the Wing Read More »
Today, since I was working from home, I was able to get multiple steps done. At lunch I cut and glued two pieces of balsa cut from the 3/8” thick balsa Peter provided me and glued them together. I then clamped it and left it to dry, seen below:
Building Aero 3D Day 41: Wing Bolt Support Block Read More »
So, finishing the thought from my previous post the epiphany I had while trying to sleep was that during my last session with Peter the plan was to glue the trailing edge (W-TE-1, 1/4” x 3/8“, ) on while the hinge support blocks were still exposed. This allowed me to use them as anchors for
Building Aero 3D Day 40: Trailing Edge Glued Read More »
Sunday, I couldn’t take not building anymore so I went rogue and got back to work on my aircraft. I started prepping the back of the wing so I could add W-TE-1. First I was thinking about the trailing edge and looked at making the W-TE-2 pieces. For this I took a piece of 3/32“, 4”
Building Aero 3D Day 39: Trailing Edge Work Read More »
Wednesday, Peter came over and we made some more progress. Could only do a little bit as the trailing edge is required to continue. First, using a forstner drill bit, I drilled a hole into the top center of the wing. Peter held a piece of ply behind to help prevent the balsa sheeting from
Building Aero 3D Day 38: Trailing Edge Read More »
Sunday, Peter & I did some more work along the trailing edge of the wing. I started by continuing where we left off cutting down the trailing edge. I took a few more passes with the utility knife and then moved on to using a sanding block to get it flush with the back tip
Building Aero 3D Day 37: Hinge Supports Read More »
Yesterday Peter came over and we got to looking at the ‘instructions’ again. It appears the top and bottom sheets go right to the trailing edge along the ribs and then a cap goes right along the back. Because of that I started cutting off the excess WKA/WKB that has been hanging around incrementally using
Building Aero 3D Day 36: Trailing Edge Trim & Bottom Sheeting Read More »
Wednesday we completed Step 4 of the wing instructions (minus cutting flush the trailing edge). Peter brought all the W-SH-5’s & W-SH-4’s he cut at home out of 3/32” balsa a bit longer then required. I lined one of the pieces up on a rib, marked how much needed to be sanded off one end
Building Aero 3D Day 35: Wing Top Sheeted Read More »
