Sunday, I couldn’t take not building anymore so I went rogue and got back to work on my aircraft. I started prepping the back of the wing so I could add W-TE-1. First I was thinking about the trailing edge and looked at making the W-TE-2 pieces. For this I took a piece of 3/32“, 4” […]
Building Aero 3D Day 39: Trailing Edge Work Read More »
Wednesday, Peter came over and we made some more progress. Could only do a little bit as the trailing edge is required to continue. First, using a forstner drill bit, I drilled a hole into the top center of the wing. Peter held a piece of ply behind to help prevent the balsa sheeting from
Building Aero 3D Day 38: Trailing Edge Read More »
Sunday, Peter & I did some more work along the trailing edge of the wing. I started by continuing where we left off cutting down the trailing edge. I took a few more passes with the utility knife and then moved on to using a sanding block to get it flush with the back tip
Building Aero 3D Day 37: Hinge Supports Read More »
Yesterday Peter came over and we got to looking at the ‘instructions’ again. It appears the top and bottom sheets go right to the trailing edge along the ribs and then a cap goes right along the back. Because of that I started cutting off the excess WKA/WKB that has been hanging around incrementally using
Building Aero 3D Day 36: Trailing Edge Trim & Bottom Sheeting Read More »
Wednesday we completed Step 4 of the wing instructions (minus cutting flush the trailing edge). Peter brought all the W-SH-5’s & W-SH-4’s he cut at home out of 3/32” balsa a bit longer then required. I lined one of the pieces up on a rib, marked how much needed to be sanded off one end
Building Aero 3D Day 35: Wing Top Sheeted Read More »
Friday Peter & I got some more sheeting done on the top of the wing. The first piece was the curved middle piece sheeting the middle of the wing. In order to do this we cut a piece of 3/32“, 4″x62”, to make W-SH-2 to go to curve out to between the middle of the ‘enclosing’
Building Aero 3D Day 33 & 34: Top Sheeting Read More »
Wednesday the wing was flipped over and we went through the same process as last time to get the two pieces of sheeting on.
Building Aero 3D Day 32: Last Session Mirrored Read More »
Wednesday we started the process of sheeting the wing. Prior to actually sheeting we went over the whole wing doing some sanding, removing any excess glue gobs, rough edges, etc. making sure everything was finished as best we could. This is to make sure the sheeting sits down properly and eliminate as many covering issues/bumps
Building Aero 3D Day 31: Sheeting Wing Begins Read More »
