On January 20th, since the fiber-glass placed around the edges of the bottom of the aircraft was dry it was time to prep for the next phase.
If you look closely at the fiber-glass along the edges in the previous post you’ll notice some really rough spots where glue pooled and dried.
This involved wet sanding the roughness out of the fiber-glass as well as any excess that was hanging over the edges, namely off the bottom over the drop between the front half and back (tail) half.
I also applied the fiber-glass to the seam where the light balsa curves up under the trailing edge of the bottom balsa piece. You can see the excess handing out past the sides.
