Noteworthy moments in my hobbies and tracking my R/C Plane builds (majority).
On April 12th I worked on the wing and the fuselage. I glued the bottom mid-section of the fuselage in place which involved using glue along the edges to hold it to the fuselage as well as along the front edge to hold the bottom the flat surface it butts up against in the front. […]
Building Seamaster Day 15: Fuselage Bottom + Wing Tips Read More »
On April 7th I worked on the floats… sanding of them already took place and so I verified and then glued the sides to the support pieces. You can see the system rigged up below to keep pieces in place along with clamps on the glue joints while the glue dried. The other thing
Building Seamaster Day 14: Float Sides & Fuse Side Joints Read More »
On March 24th there was some good and some bad. One of the bad’s can be seen above in that in shaping the nose it took on a ‘funky’ warping causing the one side to bow in. You’ll see this better in a front on shot later. Added some supports to the nose as well
Building Seamaster Day 13: Fuselage Nose & Wing Read More »
On March 21st I made some more progress on both the wing and the fuselage. On the fuselage I got the top of the fuselage glued in place. The wholes, that came pre-cut, are to trim weight from the overall aircraft. In the photo below you can see where I glued the sheeting for the
Building Seamaster Day 12: Fuse top & Wing Sheeting Read More »
On March 17th I got the main spar of one of the wing panels glued in place (seen below) and also got the sheeting glued to the bottom of the tail. Used hardwood strips to provide a surface to hold the sheeting in place with clamps along the bottom edges of the side while the
Building Seamaster Day 11: Wing & Fuse Bottom Read More »
Well, do to life’s circumstances I have gotten very far behind on my blog posts for this project. I’ve gotten married, bought a house, done a lot of painting and packing, moved into said house and have done a lot of unpacking and organising. This meant that over the course of the Winter and Spring
Building Seamaster Day 10: Fuse Nose + Wing Panel Read More »
On March 6th not a whole lot of progress was made and some backtracking and discussion occurred. Discovered that the fuselage had warped. Looking down the fuse you could see that at the tail it curved inwards instead of ‘straight’ back and at the nose it was not curving properly either. This lead to much
Building Seamaster Day 9: Fuselage Woes + L Wing Read More »
Made it to Peters March 5th to work on the fuselage a bit and really get the R wing panel moving along. You can see the image above that I sanded, using an electric sander, off the overhang of the fuselage bottom I previously installed to ensure a smooth finish with the fuselage sides. Next
Building Seamaster Day 8: Fuse Bottom Edge & Wing Panel Read More »
