Today, I worked mostly on the wing tip. I started with the right wing tip and prepped the WT2 through WT4 pieces. I started at the leading edge with WT2, making sure they fit nicely and then glued them in place, using pins each time since it is an awkward shape to clamp. I marked […]
Building Aero 3D Day 46: Wing Tip & Wire Support Read More »
Yesterday, made more progress on the aircraft started by sanding the trailing edge keeping my sanding block at the same angle as the sheeting along the ribs to try and get some slipstreaming going. Though the instructions suck, I believe that is what I was suppose to do to compelete Step 5 of the Wing
Building Aero 3D Day 45: Wing Tips & Pictures Read More »
Yesterday, after work I went straight to the workshop as I wanted to get my previously cut and sanded rib caps and W-SH-3 sheet (middle section) glued. As typical, I used wood glue and after marking the mid-sections on any previously missed rib caps I applied glue to the top of the ribs and along
Building Aero 3D Day 44: Rib Caps & Sheeting Glued Read More »
Yesterday, I made some more progress on my wing in stages throughout the day. The first session of the day was involved getting the remainder of the bottom trim glued in place. I already had the piece made so it was more about figuring out how to get everything down and in place. I discovered
Building Aero 3D Day 43: Trim & Rib Caps Read More »
Today, I made some more progress on the wing of my aircraft. I started this morning with the beginnings of rounding the leading edge by using a plane to take of the initial corner and then sand paper rounded over the leading edge moving top to bottom as well as along the leading edge from
Building Aero 3D Day 42: Various Aspects of the Wing Read More »
Today, since I was working from home, I was able to get multiple steps done. At lunch I cut and glued two pieces of balsa cut from the 3/8” thick balsa Peter provided me and glued them together. I then clamped it and left it to dry, seen below:
Building Aero 3D Day 41: Wing Bolt Support Block Read More »
So, finishing the thought from my previous post the epiphany I had while trying to sleep was that during my last session with Peter the plan was to glue the trailing edge (W-TE-1, 1/4” x 3/8“, ) on while the hinge support blocks were still exposed. This allowed me to use them as anchors for
Building Aero 3D Day 40: Trailing Edge Glued Read More »
Sunday, I couldn’t take not building anymore so I went rogue and got back to work on my aircraft. I started prepping the back of the wing so I could add W-TE-1. First I was thinking about the trailing edge and looked at making the W-TE-2 pieces. For this I took a piece of 3/32“, 4”
Building Aero 3D Day 39: Trailing Edge Work Read More »
